Looking for a way to protect your trees, especially during the winter? Look no further than tree wrap! Tree wrap is an inexpensive and easy way to keep your trees healthy during the winter months. In this blog post, we will discuss what tree wrap is, when to use it, and how to install it properly. Stay warm this winter – let tree wrap take care of your trees!
P.S. If you need help removing that pesky tree from your property! We’ll make sure everything goes well and you can find the best tree removal companies in town at this link for any job needs.
What Is Tree Wrap?
Tree wrap is used to protect young trees and thin-barked trees from extreme temperature fluctuations, burns from the sun reflecting off the snow, and certain animals.
Sunscald
When the sun reflects off the snow, it can cause sunscald on your trees. Sunscald is when the bark of the tree gets heated up and then cools down too quickly, causing it to crack. This makes the tree susceptible to diseases and pests.
Windburn
Windburn is when the wind dries out the tree’s bark, causing it to crack and peel. This makes the tree more susceptible to diseases and pests.
Animals
Certain animals, such as rabbits and deer, will try to eat the bark off of trees during the winter. This can damage or kill the tree.
Tree wrap comes in many different materials, including cloth, paper, and plastic. It is important to choose the right type of tree wrap for your climate and your tree species.
When To Use Tree Wrap?
In general, you should put tree wrap on your trees from the beginning of fall until the end of spring. Sunscald and windburn are two of the main reasons why you would want to use tree wrap. This will protect your trees from the harshest weather conditions.
How To Use Tree Wrap
Installing tree wrap is easy! Just follow these simple steps:
Step 1 – Measure the circumference of the tree trunk at breast height (around four feet from the ground).
Step 2 – Cut the tree wrap to size, allowing for an overlap of about two inches.
Step 3 – Starting at the bottom of the tree trunk, secure the tree wrap with duct tape or another type of strong tape.
Step 4 – Wrap the tree trunk in a spiral pattern, working your way up to breast height.
Step 5 – Overlap each layer of tree wrap by about two inches.
Step 6 – Secure the top of the tree wrap with duct tape or another type of strong tape.
Step 7 – Trim any excess tree wrap.
That’s it! You’ve successfully installed tree wrap on your tree. Just be sure to remove it in the spring, after the last frost.
When To Remove Tree Wrap?
You should remove tree wrap in the spring, after the last frost. This is to prevent the tree’s bark from getting too hot and drying out.
How Often Should You Replace Tree Wrap?
You should replace tree wrap every year, or as needed. If you notice any rips or tears, be sure to replace the tree wrap as soon as possible.